Output Details and Examples — EnergyPlus 8.2

<< Prev | Table of Contents | Next >>

readvars.rvaudit[LINK]

This file is available from standard EnergyPlus runs (batch file, EP-Launch, etc) where the included utility “ReadVarsESO” is used to create .csv or other delimited files. It shows what steps were taken during the read vars run(s) - in standard EnergyPlus runs there are two: one for the .eso file and one for the .mtr file. Contents might be:

Mon 04/02/2007 19:34:17.09 ReadVars
 ReadVarsESO
 processing:eplusout.inp
 input file:eplusout.eso
 output file:eplusout.csv
 found/finding:
     1 Outdoor Dry Bulb
     6 Zone/Sys Air Temperature
     6 Zone/Sys Sensible Cooling Rate
     6 Zone/Sys Sensible Heating Rate
     6 Total Water Heating Coil Rate
     1 Total Water Cooling Coil Rate
     1 Sensible Water Cooling Coil Rate
     2 Plant Loop Cooling Demand
     2 Plant Loop Heating Demand
     1 Boiler Gas Consumption Rate
     1 Boiler Heating Output Rate
     1 Chiller Electric Power
     1 Chiller Evap Heat Trans Rate
     1 Chiller Evap Water Inlet Temp
     1 Chiller Evap Water Outlet Temp
     1 Chiller Evap Water Mass Flow Rate
     1 Chiller Cond Heat Trans Rate
     0 Chiller Cond Water Inlet Temp
     0 Chiller Cond Water Outlet Temp
     0 Chiller Cond Water Mass Flow Rate
     2 Pump Mass Flow Rate
     2 Pump Outlet Temp
 ReadVars Run Time=00hr 00min  1.78sec
 ReadVarsESO program completed successfully.
 ReadVarsESO
 processing:test.mvi
 input file:eplusout.mtr
 output file:eplusmtr.csv
 getting all vars from:eplusout.mtr
 ReadVars Run Time=00hr 00min  0.00sec
 ReadVarsESO program completed successfully.