What EnergyPlus Isn’t[LINK]
- a user interface. It is intended to be the simulation engine around which a third-party interface can be wrapped. Inputs and outputs are simple ASCII text that is decipherable but may be best left to a GUI (graphical user interface). The current known third-party interfaces/tools can be found at
http://apps1.eere.energy.gov/buildings/energyplus/interfaces_tools.cfm
a life cycle cost analysis tool. It produces results that can then be fed into an LCC program.
an architect or design engineer replacement. It does not check input, verify the acceptability or range of various parameters (expect for a limited number of very basic checks), or attempt to interpret the results. However, it does have several reporting features to help you do exactly that.
What EnergyPlus Isn’t[LINK]
http://apps1.eere.energy.gov/buildings/energyplus/interfaces_tools.cfm
a life cycle cost analysis tool. It produces results that can then be fed into an LCC program.
an architect or design engineer replacement. It does not check input, verify the acceptability or range of various parameters (expect for a limited number of very basic checks), or attempt to interpret the results. However, it does have several reporting features to help you do exactly that.
Documentation content copyright © 1996-2015 The Board of Trustees of the University of Illinois and the Regents of the University of California through the Ernest Orlando Lawrence Berkeley National Laboratory. All rights reserved. EnergyPlus is a trademark of the US Department of Energy.
This documentation is made available under the EnergyPlus Open Source License v1.0.