Plant Temperature
Source Component[LINK]
This component (Object: PlantComponent:TemperatureSource)
is a simple object used to simulate systems with a known
supply temperature. This could include a river, well, or
other configuration where a known temperature is pumped back
into the plant system. This fluid could be isolated from
chilled water and other loops by using a heat exchanger
connection between the loops.
The temperature of the source of this object can be either
constant or scheduled. If scheduled, it could also be
actuated by EMS to allow a calculated temperature at
run-time.
The logic of this component is quite simple: if there is
flow through the component, the outlet temperature is always
the source temperature. The component requests flow from the
design flow rate, which can be autosized.
Plant Temperature Source Component[LINK]
This component (Object: PlantComponent:TemperatureSource) is a simple object used to simulate systems with a known supply temperature. This could include a river, well, or other configuration where a known temperature is pumped back into the plant system. This fluid could be isolated from chilled water and other loops by using a heat exchanger connection between the loops.
The temperature of the source of this object can be either constant or scheduled. If scheduled, it could also be actuated by EMS to allow a calculated temperature at run-time.
The logic of this component is quite simple: if there is flow through the component, the outlet temperature is always the source temperature. The component requests flow from the design flow rate, which can be autosized.
Documentation content copyright © 1996-2026 The Board of Trustees of the University of Illinois and the Regents of the University of California through the Ernest Orlando Lawrence Berkeley National Laboratory. All rights reserved. EnergyPlus is a trademark of the US Department of Energy.
This documentation is made available under the EnergyPlus Open Source License v1.0.