District Heating[LINK]
When the user is not interested in a plant simulation or
there is some centralized source of hot water, the following
model can be used in the input. This allows the user to
achieve a simulation without specifying operating parameters
or curve fits for boiler models. This model only needs the
connections to the loop and the nominal capacity to simulate.
See the InputOutput Reference for additional information
(Object: DistrictHeating). This model calculates the output
capacity necessary from the inlet temperature to the setpoint
temperature for that loop with the given mass flow rate in
Watts.
District Heating[LINK]
When the user is not interested in a plant simulation or there is some centralized source of hot water, the following model can be used in the input. This allows the user to achieve a simulation without specifying operating parameters or curve fits for boiler models. This model only needs the connections to the loop and the nominal capacity to simulate. See the InputOutput Reference for additional information (Object: DistrictHeating). This model calculates the output capacity necessary from the inlet temperature to the setpoint temperature for that loop with the given mass flow rate in Watts.
Documentation content copyright © 1996-2026 The Board of Trustees of the University of Illinois and the Regents of the University of California through the Ernest Orlando Lawrence Berkeley National Laboratory. All rights reserved. EnergyPlus is a trademark of the US Department of Energy.
This documentation is made available under the EnergyPlus Open Source License v1.0.