Engineering Reference — EnergyPlus 23.2

<< Prev | Table of Contents | Next >>

Plant Load Profile[LINK]

The LoadProfile:Plant object is used to simulate a scheduled demand profile. This can be useful when the building loads are already known. Demanded load and flow rate are schedules specified in the object definition. The load profile can specify heating and cooling loads. Cooling loads are entered as negative numbers. The actual load met is dependent on the performance of the supply loop components.

The LoadProfile:Plant object must be connected on the demand side of the plant loop. If desired, multiple LoadProfile:Plant objects can be combined in series and/or parallel.

Calculation Model[LINK]

Plant Load Profile in the Water Loop[LINK]

The LoadProfile:Plant object in the water loop calculates the outlet water temperature based on the inlet water temperature from the plant loop and user inputs for the scheduled plant load and the requested flow rate. The calculation can be expressed with the equation:

Tout=TinQload˙mcp

where

Tout = the outlet water temperature

Tin = the inlet water temperature

Qload = the scheduled plant load

˙m = the water mass flow rate

cp = the specific heat of water

The user requested flow rate is not always available from the plant loop. The actual flow rate used in the calculation is the lesser of the user requested value and the plant available value.

Note that the LoadProfile:Plant object can still request and receive flow even if the scheduled plant load is zero. In this case the outlet temperature will be the same as the inlet temperature. This allows users to drive the plant loop flow without necessarily affecting the loop temperature.

For reporting purposes the energy consumption of the object is calculated using the equation:

E=QloadΔt

where

E = the energy consumption

Qload = the scheduled plant load

Δt = the time step interval

Plant Load Profile in the Steam Loop[LINK]

The LoadProfile:Plant object in the steam loop calculates the outlet steam flow rate based on the inlet condensate temperature from the plant loop and user inputs for the scheduled plant load. This model accounts for the latent heat transfer and sensible cooling of water. Steam enters the load profile component at quality equal to 1.0, at saturation temperature and leaves the load profile component with desired degree of sub cooling. The user inputs the desired degree of subcooling, which determines the condensate outlet condition from the load profile component. The calculation can be expressed with the equation:

where

= the outlet steam mass flow rate

Qload = the scheduled plant load

hfg = the steam latent heat of vaporization

= the temperature difference between saturation temperature and condensate temperature

= the condensate heat capacity