Standard error message format changes depending on where the error message is coming from. The standard error message format for GetInput goes something like this:
<modulename><routine name>: <object name> = <name field> “condition”
<several lines with more information may follow>
The <modulename>(optional) <routinename> part is so that people answering support questions can more easily find the code, if necessary and without running the input file through the debugger.
As noted elsewhere, errors come in several flavors with typical user responses required.
In the examples for this section, the severity (Warning/Severe/Fatal) will be left off the message unless necessary for the rest of the example. For example:
GetPlantLoopData/GetPlantAvailabilityManager: AvailabilityManagerAssignmentList = ALWAYS_ON not found in lists. No availability will be used.
Here the routine GetPlantLoopData/GetPlantAvailabilityManager for object AvailabilityManagerAssignmentList with name Always_On is not found. And then the result is shown. (This is a warning level error, by the way).
The development team is working to standardize the error format, as time allows. So, sometimes you will likely see something like:
Check input. Pump nominal power or motor efficiency is set to 0, for pump = HEAT RECOVERY CIRC PUMP
Here, at least you know which pump (Heat Recovery Circ Pump) has the power or motor efficiency of 0.
Standard Error Message Format[LINK]
Standard error message format changes depending on where the error message is coming from. The standard error message format for GetInput goes something like this:
<modulename><routine name>: <object name> = <name field> “condition”
<several lines with more information may follow>
The <modulename>(optional) <routinename> part is so that people answering support questions can more easily find the code, if necessary and without running the input file through the debugger.
As noted elsewhere, errors come in several flavors with typical user responses required.
In the examples for this section, the severity (Warning/Severe/Fatal) will be left off the message unless necessary for the rest of the example. For example:
GetPlantLoopData/GetPlantAvailabilityManager: AvailabilityManagerAssignmentList = ALWAYS_ON not found in lists. No availability will be used.
Here the routine GetPlantLoopData/GetPlantAvailabilityManager for object AvailabilityManagerAssignmentList with name Always_On is not found. And then the result is shown. (This is a warning level error, by the way).
The development team is working to standardize the error format, as time allows. So, sometimes you will likely see something like:
Check input. Pump nominal power or motor efficiency is set to 0, for pump = HEAT RECOVERY CIRC PUMP
Here, at least you know which pump (Heat Recovery Circ Pump) has the power or motor efficiency of 0.
Documentation content copyright © 1996-2015 The Board of Trustees of the University of Illinois and the Regents of the University of California through the Ernest Orlando Lawrence Berkeley National Laboratory. All rights reserved. EnergyPlus is a trademark of the US Department of Energy.
This documentation is made available under the EnergyPlus Open Source License v1.0.