readvars.rvaudit[LINK]

This file is available from standard EnergyPlus runs (batch file, EP-Launch, etc) where the included utility “ReadVarsESO” is used to create .csv or other delimited files. It shows what steps were taken during the read vars run(s) - in standard EnergyPlus runs there are two: one for the .eso file and one for the .mtr file. Contents might be:

    Mon 04/02/2007 19:34:17.09 ReadVars
     ReadVarsESO
     processing:eplusout.inp
     input file:eplusout.eso
     output file:eplusout.csv
     found/finding:
         1 Outdoor Dry Bulb
         6 Zone/Sys Air Temperature
         6 Zone/Sys Sensible Cooling Rate
         6 Zone/Sys Sensible Heating Rate
         6 Total Water Heating Coil Rate
         1 Total Water Cooling Coil Rate
         1 Sensible Water Cooling Coil Rate
         2 Plant Loop Cooling Demand
         2 Plant Loop Heating Demand
         1 Boiler Gas Consumption Rate
         1 Boiler Heating Output Rate
         1 Chiller Electric Power
         1 Chiller Evap Heat Trans Rate
         1 Chiller Evap Water Inlet Temp
         1 Chiller Evap Water Outlet Temp
         1 Chiller Evap Water Mass Flow Rate
         1 Chiller Cond Heat Trans Rate
         0 Chiller Cond Water Inlet Temp
         0 Chiller Cond Water Outlet Temp
         0 Chiller Cond Water Mass Flow Rate
         2 Pump Mass Flow Rate
         2 Pump Outlet Temp
     ReadVars Run Time=00hr 00min  1.78sec
     ReadVarsESO program completed successfully.
     ReadVarsESO
     processing:test.mvi
     input file:eplusout.mtr
     output file:eplusmtr.csv
     getting all vars from:eplusout.mtr
     ReadVars Run Time=00hr 00min  0.00sec
     ReadVarsESO program completed successfully.